Honda Highness CB 350/ GB 350Touring Complete Seat Assembly

Honda Highness CB 350/ GB 350 Touring Complete Seat Assembly

Compatibility : Honda Highness CB 350

Base: The seat base is made of fiberglass. We use fiberglass to make the seat base (OEM is ABS Plastic) for Highness as it would increase the life of the seat base, and simultaneously it would not have rust issues like the metal base has.

Foam: The main cushion used is made in HD. According to our R&D team, HD foams are best for touring. Hence, we have used the same for this seat.

Seat Cover: The seat cover material used for this seat has a cotton-coated backing to increase its life even more. The quality of the material is way higher than the usual one.

Not Waterproof: While the seat offers some degree of moisture resistance, it is important to note that it is not waterproof. To help limit water penetration, a plastic barrier is included between the seat cover and the main cushion, however water may seep through the needle holes in the stitched design areas, especially where the diamond and stripe patterns are sewn. While it can handle occasional splashes or brief exposure to damp conditions, the surface is not fully waterproof and may absorb water during heavy rain or prolonged wet exposure. It is recommended to use a rain cover or store the motorcycle under shelter to maintain the seat’s condition and longevity. While rainfall or water washing will not damage the seat, it may take some time to dry.

Overall:

The seat has good tail bone support for both rider and pillion to make them feel comfortable during long rides.

The seat is slightly lengthier than the stock long seat to give some extra space for the Pillion rider.

The seat is water-resistant. Though there is a plastic layer in the seat to stop water from getting through. There are possibilities of water letting in during heavy rain. However, nothing to worry about anything getting damaged.

Installation: The procedure to install the seat is quite similar when compared with the stock seat. Here the only change is the lock clamp.

Remove the lock clamp of your stock seat and use the same on our seat. You would not be provided any lock clamp along with the seat.

Note: The seat will touch the Handle Grab Rail which is provided with the single long seat. However, there will be 2 Inches Gap if used with Split Seat.

Please select the option accordingly, as we give a customization option to increase the length accordingly.

*Gel Pad: Gel Pad will be installed by us while making the seat. It acts as a Shock absorber, giving you tail bone support and protects your tail bone from speed breaker jerks. The best motorcycle Gel seat pad evenly distributes pressure, which reduces numbness. The thickness of the gel pad is 6mm.

*0.5 Inch Foam: This foam will be installed in the seat itself after you place your order. The density of the foam will be 22.